3" 5:1 Ogive Filament Wound Fiberglass Nose Cone with Stepped Tip
Out of stock
Made with high temperature epoxy and an extra strong lattice wind. The Tip is 6061 Aluminium that is stepped.
All cones come with a through the tip threaded rod linking to a recovery Eye Bolt. (Included) No Gluing! Super Strong!
The cones are already setup to easily add electronics!
Stepped Aluminum Tips For 54mm Through 4 inch Fiberglass Nose Cones
Machined 6061 Aluminum Tip that is stepped to fit inside the hollow on the end of a filament wound fiberglass nose cone. Threaded to 1/4" 20.
These tips fit 54mm, 65mm, 3 inch and 4 inch filament woundnose cones. (Some adjustment may be required on other manufacturer's cones.)
38mm LOC Nosecone. (With Fiberglass Sleeve)
Only a few left!
38mm LOC Plastic Nose Cone that is sleeved with a fiberglass sleeve to allow the ability to pin the nose cone and prevent drag separation.
54mm High Compression Fiberglass Nose Cone
Specs: 54mm (2.2") 5:1 Ogive with Stepped Aluminum Tip
54mm removable coupler. This is NOT a layup, gel coated nose cone.
About Our Compression Molded Nose Cones.
Compression molding is not necessarily a new concept, but our innovative process in composites, designed by an aerospace engineer, has taken the strength of fiberglass to a new level. The cone itself is a very strong single unit, and is highly compressed to get the maximum density and rigidity using the best resins and fiberglass available. Add to that, a stepped aluminum tip that eliminates “side slip” and you have one of the smoothest, strongest, most reliable nose cones in sport rocketry today!